The Maxi Chopper

This is some pictures of my chopper, based on a '71 Puch Maxi P.

Please take note of, there is nothing cut or welded, everything is wrenched off and on, so it can be turned back to stock anytime!

Front fork and rim is off a Suzuki RMX cross moped (dkkr.500,-), new front tire (dkkr.700,-), handlebars was found in a skate shop's custom bike section (dkkr.250,-), rear fender is an old Maxi front fender (spare part), seat is a swap meet find (dkkr.150,-), seat braces is old aluminum curtain holders (junk).
Total build cost: dkkr.2800,- (ca. $550,-).

Movie of me and Jan racing at Mosten Raceway (before the high handlebars):

Write a new comment: (Click here)

SimpleSite.com
Characters left: 160
DONE Sending...
See all comments

| Reply

Latest comments

27.12 | 22:29

Hallo Again i found the oilpan for the engine i do have a extra crank any blocks around?
Kind regards!
Mats

...
31.01 | 00:54

Hey Dannerr, It was justy a passing thought about the HC head, I will prpbably leave it as it is , I only use it around here, I dont go on any tours. Thanks ...

...
30.01 | 09:05

Functionwise the B-carb on the G28T should work fine, but you'll be able to get more power out of it, if opted to other carbs. :)

...
30.01 | 09:03

Looks are important- and the look of an original is gone, if mounted with downdraft carb(s).
I have seen dual updraft manifolds, which is a bit of both worlds.

...
You liked this page